rubber liquid coating > abrasion resistant spray application rubber liquid coating

abrasion resistant spray application rubber liquid coating

BD935 spray application anti abrasion wear resistant epoxy compound liquid rubber coating

Product description:
Double components, black or red liquid,low viscosity,can add appropriate anhydrous solvent further diluted,
suitable for the airless spraying(spray coating),generate the elastic rubber after curing,with strong bonding force
to the substrates,high strength,water resistant,abrasion resistant,aging resistant.can be preparation of the elastomer
of various hardness and mechanical performance index according to users’ requirements.Mainly used in the preparation
of abrasion resistant rubber coating on the surface of various equipment,or do the thicken repairing on the surface
of worn-out rubber layer.Such as the preparation of wear resistant rubber lining on the following equipment surface or
do the surface repairing and regeneration: valve,pipeline,elbow,concentric reducer,roller of magnetic separator,
flotation tank,chute,stock pan,hopper,bunker,mixing tank,shunt,conveyor belt,belt conveyor roller,fan shell and impeller,
conditioning tower,powder selecting machine,thick powder separator, filter,cyclone tube,coal drop pipe,expansion joint,
car compartment,garbage trucks cars, concrete tank car tanks,vibrating screen beam support,material storage tank etc.

Performance index of BD935 spray application wear resistant epoxy compound rubber liquid coatings:

Product Name	Physical state	Packaging	Viscosity （Pa•s）（25℃）	Operation time limit （25℃）	Curing time （25℃）
BD935 spray application wear resistant liquid rubber coating	fluid	25kg/group	Based on users’ requirements	30 min	72 hours

Density (g/cm3)	Compressive strength （Mpa）	Peeling strength （Mpa）	Hardness （shore A）	Breaking elongation （％）	Range of temperature resistance （℃）
1.35	Based on users’ requirements	Based on users’ requirements	Based on users’ requirements	Based on users’ requirements	-60～80

How to use of BD935 wear abrasion resistant spray application liquid rubber epoxy coating:
1.Surface treatment:Do the rust cleaning and coarsening processing on the pending-repair part,then clean it by cleaning agent or do the brush coating with special first coat
based on users’ requirements.

2.For the workpiece which brushed coating or sprayed coating with first coat, you can’t do the next operation
until the first coat curing

3.Configuration:Make the A and B two components mix uniformly according to the specified mass ratio.

4.Spray coating:Make the mixed-up material spray coating on the surface of the equipment with the airless sprayer.

5.Curing: it can be put into using based on curing for 72 hours at room temperature.

Storage:
This material is the general chemical,should pay attention to water resistance and fire prevention in the process of
transportation and storage.Stored in the cool and dry place,the warranty period is 6 months.

Packaging specification:
Two-component,25Kg/group,packed in a plastic drum.

Notes:
Allergic constitution should use it more carefully

Product packaging photo of BD935 spray applied two components liquid rubber abrasion wear resistant coating:

------分隔线----------------------------